![]() Enter pi as user name and raspberry as passwordĪssigning Static IP address to Raspberry Pi. ![]() Open PuTTY and access Raspberry Pi using IP Address shown in popup.Wait a while and a popup will show assigned IP address and the MAC Address of Raspberry Pi.Connect the Raspberry Pi to the computer’s LAN port using cable.Select the check box Run DHCP server immediately and click Finish.Under “Firewall Exceptions” Click on Configure and then Exit.Configure firewall by clicking Admin (Click yes on security warning).Check whether the path of “INI file” is same as the location of the dhcpsrv.exe.Leave all values as default and Click on Next.Click on Refresh, choose Local Area Network or Ethernet (depends on Windows you are using) and hit Next.Unzip the contents of Latest DHCP server for Windows ZIP file to C:\DHCP.Download DHCP server for Windows from this link.Check Validate settings upon exit (to validate settings).Select Use the following IP address option and provide an IP address (eg.Select Internet Protocol Version 4 (TCP/IPv4) and click Properties.Right click on Local Area Connection and click Properties.Go to Network and Sharing Center by searching in start menu. ![]() As both Raspberry Pi and PC both do not have IP address configured by default and cannot communicate to each other, A DHCP (Dynamic Host Configuration Protocol, automatically provides an Internet Protocol (IP) host with its IP address and other related configuration information such as the subnet mask and default gateway) server is required to be installed on PC. DHCP server for Windows perform this job with ease, just follow the steps below. But these are the requirements no more as Raspbian Jessie comes with SSH pre-enabled. Router or Access point already established. Normally new installation of Raspberry Pi needs Mouse, Keyboard and Display for configuring Raspbian Jessie especially when there is no network i.e.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |